tokam projects Apps
Traction Monitor-S (Rec+Play) 3.1.2
Fixing the device on you motorcycle, this appindicates traction force that tires griping the load.Analyzing 6 axial forces detected by built in sensors on yourdevice (X-Y-Z axial Accelerometer and Gyroscope), monitors realtime lean angle and griping force as side G-force on theload.In case gyroscope sensor is not available on your device, themonitor shows braking and acceleration force and referential leanangle calculated by centrifugal force.During braking, lean, and acceleration, when detects the forcehigher than configured alarm value, the monitor changes the buckground color from green to red and alerts the risk of slipdown.Version “S” has additional Record & Play function that savesmonitored values at each location and play it on Google-Map likerunning on the load.In addition, analyze the force distribution between Fr / Rr tireindicate the value of higher side.< Instruction >1- Fix the device using a support. (The app works on verticalorientation only.)2- Adjust the angle, forward or backward direction. But displayface must be parallel with the wheel axial shaft.3- To start the monitor, keep the motorcycle on upright position,and press [Calibrate] button to initialize sensors.4- Then press [Setting], and configure [Alarm Level] from settingmenu.5- When the Calibration and Settings are configured correctly,letters of these buttons will change to green and start themonitoring.< SETTING MENU >You can change the configuration using follow settingoptions.[ Alarm Level / Sensor Sensibility ]- Adjust minimum indicate level and alarm level (max 1.5G).- Real time or Max value keep mode.- Reset the alarm during upright acceleration.- Sensibility of G (acceleration) and Sensibility for lean angle.Bumps from the load and vibrations may affect the monitoringvalues.[ Mechanical Dimensions ]-Load distribution Front or Rear / Consider the force distributionbetween Fr/Rr and indicate the force of higher side.-Mechanical Dimensions / Parameters used to calculated loaddistribution.-Tire Size / This affect the area of surface contact with the loadand grip limit. According with the input values (tire width), thealarm level will be adjusted mathematically. (In the case Fr=120and Rr=180, width rate = 1.5. Alarm level of Rr tire changes 1.5times more comparing with Fr.) [ GPS ]- Turning on, indicates running speed. Also help to indicate leanangle, when gyroscope is not used.-Location service should be activated on High accuracy mode.[ Sound Alarm ]- Make beep sound as well as buck ground color. You can hear it byan earphone if connected by wire or Bluetooth.[ Buck Ground Color ]-Change buck ground color gray back or white base.< ADJUSTMENT FUNCTIONS >[ Sensor Sensitivity Calibration ]Calibrate zero and gain of Accelerometer. Moving the device up,down, left, and right, along the shown message, finish calibrationautomatically.- For safety reason, app buttons will be blocked when moving withspeed. You need to stop to operate.- This app should be used for safety and efficient ride as well asgeneral indicators and speed meter. You need to drive with due careand attention. The developer disclaims any liability for any lossor damage in connection with the use of this app.Thank you for donate. Enjoy the Ride!
